How to setup Netgear Router and change admin Login password

Setup a Netgear Router (Step-by-Step) And Change Password



I will be showing you how to set up or configure your Netgear Wireless Router. This was divided into 3 simple steps.


  • First one Setting up your Netgear Router to PC

  • The second one is how to get the Netgear Router Login page to configure it.

  • The third one is resetting your Netgear Router Password.



First one, Setting up your Netgear Router to PC

Take your router and power it up using Adapter supplied with a retail package.

Connect the cable to the colored port. Now take the LAN cable and connect it to any one of the LAN port.

The other end of the LAN cable should be connected to PC LAN input.



Netgear Route



In case if you would like to configure your Netgear Router with a Modem, then follow this method. This practice helps you to auto dial-up your network for example in this case say BSNLnetwork.

Take your Modem and input your ISP to the LINE port of Modem. Now take a LAN cable and connect it to your Modem.

The other end of the LAN cable should be connected to the colored part of the Router as Input.


Netgear Router and change admin Login password





Now get another LAN cable and input the same to router LAN port and PC LAN Port.

In this case, you need to configure both Modem and Router separately.

Your first step is now completed.



Samsung





Second, getting the login page of Netgear Router and the configuration part.

Turn your router to find the login IP address of Netgear Router. If you are not able to find it, try the following IP addresses.

Make sure to power up your router before implementing this steps.

  • routerlogin.net
  • router login.com
  • 192.168.0.1
  • 192.168.1.1

If you get the login page, enter the default values like a username as "admin" and password as "password" or "1234".


Netgear Router and change admin Login password




If you are not able to get the Netgear RouterLogin Page with these IP addresses or failed to login with default login credentials, then follow the method to reset the router which I will be able to be showing you.

Hope you bought the admin panel of the router. Here, attend Wireless Settings Tab and select"Enable SSID Broadcast".

Name your SSID, Region and select WPA2-PSK [AES] in Security Options then enter the password that you would like to use to connect with Wireless Network.

That's it. You have successfully configured the Netgear Wireless Router.


The third step to know them thanks to resetting Netgear Wireless Router. Turn your router to the rear and next to your antenna, there'll be a little pin switch.


Netgear Router and change admin Login password




Take a pen or pencil and press this switch for about 10 seconds. Now, wait for a few minutes and try to login with the previous IP address and credentials.

Hope you find this useful.

If you face any issues do comment below. Do a share if you think worth sharing.






Post a Comment

2 Comments

Hi,
If you have any doubt please let me know!
Thanks